LinkSprite Learning Center

[...] to computer, copy the system image and update.sh file directly to TF card: b. Connect the pcduino3 Nano with the screen, power for pcDuino3 Nano, the screen will show as following: c. Install the TF [...]

[...] In this tutorial, we show how to use Linker Real Time Clock (RTC) module on pcDuino3 Nano. Hardware Connection: The schematic can be shown below: The actual hardware wiring as below: [...]

[...]

[...] The $39 single board computer pcDuino3 Nano is well received after its launch. There are cases that users want LCD of difference form [...]

[...] IDE. Then click the button, and you will see the desk lamp will change light on or off. Previous slide Next slide [...]

[...] , 0100100, 01000100, 01000010. The original post from http://www.hoverlabs.co/pcduino Previous slide Next slide [...]

[...] ( respectively are the output information of receive port (left) and send port (right)). Previous slide Next slide [...]

[...] put the tag to the sensing area of RC522 module, then you can read the card information: Previous slide Next slide [...]

[...] show how to turn on the serial debug port function when using ARPI600: Raspberry Pi B+ to Arduino Adapter HAT for Raspberry Pi B+. [...]

In this post, we will describe how to set the serial port of Raspberry B+ to be a communication serial port that can be used to control other peripher [...]

In this post, we will discuss how to configure RTC for Raspberry Pi B+. 1. Install the jumper on the headers labeled ‘RTC JMP’. 2. Enter the fol [...]

[...] will print out the AD value, which is by default the AD0 of TLC1543, or T_A0 of the Arduino adapter hat. 5) If T_A0 is connected to A0, A0 of Arduino headers can be used as the AD converter pins. [...]

[...] shown. The 3 points is default not soldering at the factory. Arduino has a 2*3 pins with SPI interface, but pcDuino doesn’t have that SPI interface. When you soldered the 3 points, pcDuino will [...]

[...] ports, such as SPI, UART and I2C.  Right now, the sample code we provide has only SPI interface. The external power supply is specified to be between 7V to 24V.   The three pins header SWD [...]

[...] diagnostic bus.The CAN – BUS expansion board adopt the CAN BUS controller of MCP2515, SPI interface and MCP2551 CAN transceiver, communicate with your Arduino. With OBD II conversion line and [...]

[...] the “png”as the new role, adjust the role size with . Write the following script at the instruction script area for the characters. FIgure 1-3 The script for SunWukong born Notice: for the button [...]

[...] ”as the new role, adjust the role size with . 4.Write the following script at the instruction script area for the characters. Choose instruction and change the port number to A4, and the [...]

[...] “png”as the new role, adjust the role size with .4.Write the following script at the instruction script area for the characters. set the role beginning state size. set the initial position. [...]

[...] ”as the new role, adjust the role size with . 4.Write the following script at the instruction script area for the characters. is to show the switch current voltage. The current voltage [...]