PIPING GUIDE

[...] ASME B31.3 Process Piping - Perform flexibility AnalysisWhat are we trying to achieve? 1. Provide adequate support to [...]

[...] ASME B31.3 Process Piping - Layout and SupportGeneral Considerations Access for operation (valves)Access for [...]

[...] Pressure Piping, listed below: ● B31.1, Power Piping ● B31.2, Fuel Gas Piping ● B31.3, Process Piping ● B31.4, Liquid Transportation Systems for Hydrocarbons, Liquid Petroleum Gas, [...]

[...] ASME B31.3 Process Piping Course Introduction in Accordance with Design, Construction, and Mechanical IntegritySeries [...]

[...] factors, and materials-related factors which must be considered in the detailed design of a piping system, to ensure its pressure integrity over its design life. Physical AttributesPhysical attributes [...]

[...] installed cost, the long-range operating and maintenance cost, and the performance of the piping system. Factors that must be considered in the joint selection phase of the project design include [...]

[...] In practice, the assurance that the design and construction of a piping system will meet prescribed pressure-integrity requirements is achieved through the use of published [...]

The term heat-tracing refers to the continuous or intermittent application of heat to a pipeline or vessel in order to replace heat loss to ambient. T [...]

[...] with Project B31 in March 1926, the first edition of American tentative Standard Code for Pressure Piping was published in 1935. In view of continuous industry developments and increases in [...]

[...] requirements for piping support are included in the sections of ASME B31, Code for Pressure Piping, listed below: ● B31.1, Power Piping ● B31.2, Fuel Gas Piping ● B31.3, Process [...]

[...] as per table below: This course will review the basic requirements of the ASME B31 Code for Pressure Piping with emphasis on B31.3, Process Piping. General topics in the course include Code... [[ This [...]

The function of a gasket is to conform to the irregularities of the flange faces to affect a seal, preventing the inside fluid from leaking out. See f [...]

The function of a bolt is to provide a clamp load or preload (Fp) to sufficiently compress and stress the gasket and resist the parting forces exerted [...]

Bolts and nuts should be selected to conform to the design specifications set out with the flange design. Care is taken to ensure that the correct gra [...]

Tubular products are termed ‘tube’ or ‘pipe’. Tube is customarily specified by its outside diameter and wall thickness, expres [...]

Scope This code prescribes requirements for the materials, design, fabrication, assembly, erection, examination, inspection, and testing of piping wi [...]

Scope ASME B31.9 applies to the following building services: œ Water for heating and cooling œ Condensing water œ Steam or [...]