Mobile-part.com: Latest News

[...] from the motherboard. Pull the connector straight up and out of its socket. Blu-ray drive Retaining flap Lift the Blu-ray drive from the edge nearest the power supply and rotate it away from the [...]

[...] . Pry from underneath the cable. Step 11 Using the flat end of a spudger, flip up the retaining flap on the camera ribbon ZIF connector. Use the pointed end of a spudger to pull the camera [...]

[...] of the DSi. Step 10 Use your fingernail or the edge of a plastic opening tool to flip up the retaining flap on LED indicator ZIF connector. Be sure you are prying up on the hinged retaining flap, not [...]

[...] devices. With a plastic opening tool, begin to gently pry the rear case down, away from the display assembly, while you pull up with the suction cup. There are several [...]

[...] devices. With a plastic opening tool, begin to gently pry the rear case down, away from the display assembly, while you pull up with the suction cup. There are several [...]

[...] assembly to the rear case, so you may need to use a combination of the suction cup and plastic opening tool to free the front panel assembly. Step 4 Continue to pry up around the sides of the front [...]

[...] assembly to the rear case, so you may need to use a combination of the suction cup and plastic opening tool to free the front panel assembly. Step 4 Continue to pry up around the sides of the front [...]

[...] out of its socket on the motherboard. Step 8 Use your fingernail or the edge of a plastic opening tool to flip up the retaining flap on power board ZIF connector. Be sure you are prying up on [...]

[...] case. Step 6 Remove the following screws securing the front panel assembly cable bracket to the logic board: Two 1.2 mm Phillips screws One 1.6 mm Phillips screw Step 7 Remove the front panel assembly [...]

[...] rear cover and remove the rear cover from the logic board assembly. Step 7 - Heat Sink Motherboard fan Memory card reader Disconnect the fan from the [...]

[...] case. Step 6 Remove the following screws securing the front panel assembly cable bracket to the logic board: Two 1.2 mm Phillips screws One 1.6 mm Phillips screw Step 7 Remove the front panel assembly [...]

[...] . Step 2 - Removing Top Cover Screw locations Remove the following seven screws, (6) 52mm Phillips screws and (1) 30 mm Phillips screw. Lift the top cover from its rear edge and rotate it toward the [...]

[...] Step 1 — Battery Remove the two Phillips screws securing the battery cover to the back of the handheld console. Lift the battery cover off [...]

[...] Step 1 — Battery Unscrew the two Phillips screws securing the battery cover to the lower case. The screws remain captive to the battery cover. [...]

[...] away from the front of the Wii. Use a pair of tweezers to disconnect the LED cable's plastic connector from the motherboard. Remove the faceplate. Step 7 — Outer Case Open the controller port [...]